Hello, has anyone ever seen the following error? We are getting this error in our basic transformer stage.
'Received signal SIGBUS'
Thanks for your help!
Basic Tranformer Error Message
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
SIGBUS is a UNIX signal. It means that there has been a "bus error". The "bus" referred to here is usually the communication channel between the CPU and memory or other hardware components.
Thus, you are being told in UNIX's beautifully succinct way that your application has done something that has caused, or detected, an error.
The man page for siginfo will tell you that there are three major reasons for raising this signal:
Thus, you are being told in UNIX's beautifully succinct way that your application has done something that has caused, or detected, an error.
The man page for siginfo will tell you that there are three major reasons for raising this signal:
- invalid address alignment
non-existent physical address
object-specific hardware error
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Basic Tranformer Error Message
Rstone,
Did you resolve this issue? If so, what was the resolution?
Your descriptions of the Basic Transform in PX make it seem like the Basic Transform is buggy.. Care to comment?
Did you resolve this issue? If so, what was the resolution?
Your descriptions of the Basic Transform in PX make it seem like the Basic Transform is buggy.. Care to comment?
-
- Participant
- Posts: 75
- Joined: Tue May 13, 2003 4:14 am
- Location: California
- Contact: