Import Issues from one region to another

A forum for discussing DataStage<sup>®</sup> basics. If you're not sure where your question goes, start here.

Moderators: chulett, rschirm, roy

Post Reply
sandhya.budhi
Premium Member
Premium Member
Posts: 18
Joined: Wed Nov 15, 2017 10:50 am

Import Issues from one region to another

Post by sandhya.budhi »

I am trying to import datastage sequence from one environment to another and it is giving an error when I do the same.

"Not Attached to a job"


After the import when I try to open the sequence it is showing the message "This item has no design time information"

I thought the sequence was corrupted and created a new sequence again. But still I am getting the same error when I try to do the import.
Thanks,
Sandhya
chulett
Charter Member
Charter Member
Posts: 43085
Joined: Tue Nov 12, 2002 4:34 pm
Location: Denver, CO

Post by chulett »

First step would be to detail for us how you are doing the export / import - tool used, syntax, etc.
-craig

"You can never have too many knives" -- Logan Nine Fingers
ray.wurlod
Participant
Posts: 54607
Joined: Wed Oct 23, 2002 10:52 pm
Location: Sydney, Australia
Contact:

Post by ray.wurlod »

That message typically indicates that only the job binaries - not the design time information - were exported. Whether that was intentional or not in your case is open to question.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Post Reply