automatically turn off RCP for every stages

Post questions here relative to DataStage Enterprise/PX Edition for such areas as Parallel job design, Parallel datasets, BuildOps, Wrappers, etc.

Moderators: chulett, rschirm, roy

Post Reply
abyss
Premium Member
Premium Member
Posts: 172
Joined: Thu May 22, 2014 12:43 am

automatically turn off RCP for every stages

Post by abyss »

Hi
I just turned on RCP on one of our project, current problem is we only want use rcp for some of the stages for our new jobs. but once you turn it on some existing stages from old jobs were automatically turn on.

is there a way to switch it off for all the existing jobs?

thanks
abyss
abyss
Premium Member
Premium Member
Posts: 172
Joined: Thu May 22, 2014 12:43 am

Post by abyss »

no one know? :( :( :(
chulett
Charter Member
Charter Member
Posts: 43085
Joined: Tue Nov 12, 2002 4:34 pm
Location: Denver, CO

Post by chulett »

No-one that's wandered by so far, it would seem. Have you asked your official support provider?
-craig

"You can never have too many knives" -- Logan Nine Fingers
abyss
Premium Member
Premium Member
Posts: 172
Joined: Thu May 22, 2014 12:43 am

Post by abyss »

not yet, i will do it :)
jackson.eyton
Premium Member
Premium Member
Posts: 145
Joined: Thu Oct 26, 2017 10:43 am

Post by jackson.eyton »

Out of curiosity here, when you enabled RCP at the project level, did you also check the box to "Enable Runtime Column Propagation for new links"? IF not, very strange, IF yes, can you confirm that RCP is being enabled on pre-existing jobs that have not been modified since RCP was enabled?
-Me
abyss
Premium Member
Premium Member
Posts: 172
Joined: Thu May 22, 2014 12:43 am

Post by abyss »

h double checked on admin console, i didn't NOT tick on that box.
Post Reply