I have a situation where I can run a pralell job, but when I create a sequence it does not run.
Yesterday it worked just fine, now it does not.
I have not changed anything in my enviroment.
Here is the error I get from the sequence.
Attempting to Cleanup after ABORT raised in job TI_DT_Wintid_Ansatt_SEQ..JobControl
And yes I have tried reset before compile and run
Any ideas?
Attempting to Cleanup after ABORT raised in job TI_DT_Wintid
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
My guess is that parameter values are not being passed correctly from the sequence to the job.
Check that the Job activity is configured correctly, and check both the log of the sequence and the log of the job run under its control, to see what values were used for parameters.
Check that the Job activity is configured correctly, and check both the log of the sequence and the log of the job run under its control, to see what values were used for parameters.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.