Hi,
Posting the query as a separate thread.
While using a schema file, if one has to do some transformations/calculations then how this can be done? I'm using run time col propagation and now there wont be any columns visible in the transformer (since the basic purpose of using schema file is to avoid using col defns). I actually tried putting in a transformer in b/w two seq file stages. The job ran and simply dumped the data into destination file.
Or is it so that schema file can only be used for simple load/extract?
Thanks,
Chits
How to use Transformer with a Schema file
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 12
- Joined: Mon Jul 18, 2005 4:07 am
-
- Participant
- Posts: 4
- Joined: Wed Jan 16, 2008 6:38 am
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
This post from today may help.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 4
- Joined: Wed Jan 16, 2008 6:38 am
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact: