hello,
Is there any way to enable NLS after datastage has been installed?
Enabling NLS after Installation
Moderators: chulett, rschirm, roy
You can disable NLS after DataStage has been installed if you chose to install that option at the time of the original installation. However, if you chose to not install the NLS option when you installed DataStage, you'll need to uninstall DataStage completely and then reinstall everything, this time choosing the NLS option.
Probably not the answer you were hoping for...
Probably not the answer you were hoping for...
-craig
"You can never have too many knives" -- Logan Nine Fingers
"You can never have too many knives" -- Logan Nine Fingers
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Set NLSMODE to 0 in $DSHOME/uvconfig using any text editor.
Make sure nothing is happening. Stop DataStage. uv -admin -stop
Regenerate the shared memory segment. cd $DSHOME ; bin/uvregen
Start DataStage. uv -admin -start
Make sure nothing is happening. Stop DataStage. uv -admin -stop
Regenerate the shared memory segment. cd $DSHOME ; bin/uvregen
Start DataStage. uv -admin -start
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.