Hi,
I am using Datastage 7.0.1 Parallel Jobs,when I am trying to use IConv and OConv Functions I am getting error,like Variable not found.So can we use Iconv and Oconv in parallel jobs or not.It's urgent if any body give reply i would appreciate them.
Thanks
Beeram
Reg Iconv and Oconv
Moderators: chulett, rschirm, roy
Reg Iconv and Oconv
Last edited by vbeeram on Thu Aug 26, 2004 8:50 am, edited 1 time in total.
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
There are two types of Transformer stage in parallel jobs, if you have a sufficiently recent version. One is called the Transformer stage; this one can NOT use BASIC functions such as Iconv() and Oconv(). The other is called the BASIC Transformer stage, which gives you access to the full range of DataStage BASIC expression elements, at the cost of being an additional component to load when the job runs.
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Participant
- Posts: 25
- Joined: Thu Oct 02, 2003 8:57 am