One of our sequencer job is waiting even after the job it called finished successfully (i have noticed in some cases, the sequencer finishes after 1 hr). Even though this is happening occassionally, the dw load programs are crossing our batch process window whenever this happens which creates problem in subsequent loads.
Any help will be appreciated.
Thanks.
Raj.
Sequencer Not getting the FINISH status from the job
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 54607
- Joined: Wed Oct 23, 2002 10:52 pm
- Location: Sydney, Australia
- Contact:
Review the code generated by compiling the sequence. You will find it on the Job Control tab in the job properties window. See whether there's anything there that might introduce such a delay.
Check, too, whether the controlled job has anything that might cause its status reporting to be delayed. What is that job's status in Director while this hour is passing by? Does it have a long-running after-job process, for example?
Check, too, whether the controlled job has anything that might cause its status reporting to be delayed. What is that job's status in Director while this hour is passing by? Does it have a long-running after-job process, for example?
IBM Software Services Group
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
Any contribution to this forum is my own opinion and does not necessarily reflect any position that IBM may hold.
-
- Premium Member
- Posts: 892
- Joined: Thu Oct 16, 2003 5:18 am