DSXchange

Posted: **Tue Dec 12, 2017 5:21 pm**

Hi
I just turned on RCP on one of our project, current problem is we only want use rcp for some of the stages for our new jobs. but once you turn it on some existing stages from old jobs were automatically turn on.

is there a way to switch it off for all the existing jobs?

thanks
abyss

Posted: **Wed Dec 13, 2017 5:31 pm**

no one know?

Posted: **Wed Dec 13, 2017 6:07 pm**

No-one that's wandered by so far, it would seem. Have you asked your official support provider?

Posted: **Wed Dec 13, 2017 7:04 pm**

not yet, i will do it

Posted: **Thu Dec 14, 2017 8:50 am**

Out of curiosity here, when you enabled RCP at the project level, did you also check the box to "Enable Runtime Column Propagation for new links"? IF not, very strange, IF yes, can you confirm that RCP is being enabled on pre-existing jobs that have not been modified since RCP was enabled?

Posted: **Wed Dec 27, 2017 8:51 pm**

h double checked on admin console, i didn't NOT tick on that box.

DSXchange

automatically turn off RCP for every stages

automatically turn off RCP for every stages