Hi All,
We have recently moved to DataStage v8.0 version and have been exploring the new tool.
We have built some buildops as done on v7.5 but are facing some issues on v8.0 as to the way it works.
The buildop runs fine and gives the required results. But on the interface tab of the builop for input and output tabs the Table Name value does not reflect the value we desire.
Initially when we coded the buildop we had another table name given and now want to clear the table name and add a new one, the value shown is yet the old one.
Tried all the possible ways. Can anyone please help us on this. We don't want to delete the buildop and create a new one but want to find a resolution to this.
Thanks
BuildOp Interface Issue
Moderators: chulett, rschirm, roy
-
- Participant
- Posts: 3337
- Joined: Mon Jan 17, 2005 4:49 am
- Location: United Kingdom
When i click on "Select Table" under the table name column it pops with a window to select the table definition I require.
I selec the table definition and then click OK. But the table name column yet shows the old one.
I even tried clicking on OK rather than generate and open the buildop again and see the old name.
Thanks
I selec the table definition and then click OK. But the table name column yet shows the old one.
I even tried clicking on OK rather than generate and open the buildop again and see the old name.
Thanks
-
- Participant
- Posts: 3337
- Joined: Mon Jan 17, 2005 4:49 am
- Location: United Kingdom