Page 1 of 1
Run-time error '5' Invalid procedure call or argument
Posted: Tue Aug 15, 2017 10:22 am
by Seya
Hi ,
When I try to view the Datastage Director to see the logs , while the job is running. I get this error message "Run-time error '5' Invalid procedure call or argument " When I click "OK" the director crashes.
Why does this happen and please let me know if there is a solution to this issue?
Thanks in Advance!
Posted: Tue Aug 15, 2017 11:28 am
by chulett
Guessing your client install is corrupted unless this happens to anyone else as well. If it's just you, I would suggest a re-install of the client.
Run-time error '5' Invalid procedure call or argument
Posted: Tue Aug 15, 2017 1:35 pm
by Seya
Thanks Chulett for your reply !
But, its just not me facing this issue. Other team member are having the same issue as well.
Posted: Tue Aug 15, 2017 2:11 pm
by qt_ky
Check this out.
Run-time error '5' ocurred while trying to connect to a specific DataStage project via Designer and Director clients.
http://www-01.ibm.com/support/docview.w ... wg21967583
Is the error limited to a single project (or set of projects)?
Posted: Tue Aug 15, 2017 2:53 pm
by chulett
Okay, good piece of information to know. Then as noted, your project (or projects?) have some level of corruption in them. Let us know if the tech note helps or not...
Posted: Mon Dec 10, 2018 8:29 am
by challard1
Just wanted to mention that I have got this problem in Director.
I recompiled the involved jobs and the error disappeared.